1.1 Incoming Call FeaturesFeature Guide 351.1.1.7 Intercept Routing—No DestinationDescriptionProvides automatic redirection of incoming trunk calls that do not have a destination assigned. The interceptdestination is an operator (tenant/PBX).Conditions• Intercept Routing—No Destination on/offThe Intercept Routing—No Destination feature can be enabled or disabled through systemprogramming.If disabled, a reorder tone will be sent to the caller. However, the Intercept Routing—No Destinationfeature always functions for calls through the ELCOT, LCOT, or T1 (LCOT/GCOT) card even whendisabled.• If an operator (tenant/PBX) is not assigned:The extension connected to the lowest-numbered jack will be the intercept destination.• Intercept Routing—No Destination also applies to calls from doorphones.Programming Manual ReferencesPC Programming Manual2.8.3 [2-2] Operator & BGM—PBX Operator—Day, Lunch, Break, Night2.16.7 [10-5] Miscellaneous—Intercept—Routing to Operator - No Destination (Destination is notprogrammed)PT Programming Manual[006] Operator AssignmentFeature Guide References2.2.5 Operator Features