2.5 Utility42 PC Programming Manual2.5 Utility2.5.1 Utility—DiagnosisPerforms diagnostic tests on cards installed in the PBX, to identify the source of problems.If any of the tests listed here returns the result "NG" ("No Good"), contact your dealer. Test resultscan be saved as a TXT-format (text) file.When testing is complete, any cards that were set to OUS status must be returned to INS status ifthey are to be used again.Card TestTests the relevant functions of a card to ensure that it is operating correctly. The tests carried out varyaccording to the type of card being tested.The tests that are performed on each card are as follows:A check mark indicates that the test is available for that card.To perform a card test1. From the Utility menu, select Diagnosis.2. Click on the Status cell of the card to be tested, and set it to "OUS".To perform the EXT-CID path test, set the status of both the EXT-CID card and the card in slot 1to "OUS".3. Click on the cell showing the card type.A new window will be displayed.4. Select the Card Test option.A new window will be displayed.5. Click OK to perform the test(s).The error report will be displayed. When all tests are completed, the words "Test End!" will beshown on the last line of the output.6. Select an option: SLC8HLC4PLC4PLC8LCOTECHO8MSG2SVM2DPH4EXT-CIDLocal loop back diagnosisCard CT Bus diagnosisDTMF Receive test portMSG/SVM Card DTMF receivetestEXT-CID path test
