1.6 F84 Feature ManualConditions• FLASH/RECALL Button ModeOne of the following modes can be selected for each extension through system programming:– Flash/Recall mode– Terminate mode– EFA mode. (→ 1.5.1 EFA (External Feature Access))• Terminate ButtonAny flexible button can be customized as the Terminate button.• Disconnect Time (Only for Flash/Recall Mode)The amount of time between successive accesses to the same CO line is programmable for each COline port.• This feature generates a Station Message Detail Recording (SMDR) call record (→ 1.16.1 SMDR(Station Message Detail Recording)), restarts the call timer, inserts a pause, and checks the TollRestriction (TRS) level (→ 1.17.5 TRS (Toll Restriction)) again.• The Terminate feature will be performed when pressing the FLASH/RECALL button regardless of themode that the FLASH/RECALL button has been set to, in the following situations:– When a call is made using ARS. (→ 1.1.3 ARS (Automatic Route Selection))– When a CO line call is made with the INTERCOM button.– When a CO line call is made with an Incoming Call Distribution (ICD) group button.Programming ReferencesPC Programming Manual2.7.8 [1-1] Slot—LCO Port—Disconnect Time2.10.1 [4-1-1] Wired Extension—Extension Settings—Option 6—Flash Mode during CO Conversation2.10.4 [4-1-4] Wired Extension—Flexible Button—Type2.10.8 [4-2-1] Portable Station—Extension Settings—Option 6—Flash Mode during CO Conversation2.10.10 [4-2-3] Portable Station—Flexible Button—Type2.10.13 [4-3] DSS Console—Flexible Button—TypePT Programming Manual[418] LCOT Disconnect TimeFeature Manual References1.6.3 Flexible Buttons1.6.3 Flexible ButtonsDescriptionFlexible buttons are customized through either system or personal programming. The following types offlexible buttons are found on proprietary telephones (PTs), DSS Consoles, and/or portable stations (PSs):a) Flexible CO buttonsb) Flexible Direct Station Selection (DSS) buttonsc) Programmable Feature (PF) buttons
