Panasonic FP0H Series User Manual

Also see for FP0H Series: User manual User manual User manual User manual Quick start guide

Operands Settingsn Specification of adestination unitSpecify the starting address of the device in the source data area of adestination unit.D Specification of amaster unitSpecify the device starting address of the receive data storage area inthe master unit.■ Devices that can be specified (indicated by ●)Operands WX WY WR WL SV EV DT LD In SWR SDTConstant Indexmodifier(Note 1)K HS1 ● ● ● ● ● ● ● ● ● ● ●S2 ● ● ● ● ● ●n ● ● ● ● ● ● ● ● ● ●D ● ● ● ● ● ● ● ●(Note 1) A character constant cannot be specified.■ Specifying control data [S1]Specification of [S1]To [S1], the following specification should be applied. The specification method differsdepending on word transfer and bit transfer.[S1]：Transfer inword unitsSpecify the number of send wordsH001 to H07F (1 to 127 words)H0[S1]：Transfer inbit units Master unit bit No.(H0 to HF)H8 H0 (fixed)Destination bit No.(H0 to HF)Specification of [S1+1]To [S1+1], the following specification should be applied.[S1+1]：Select a COM port（H1/H2/HF/HE）Unit No. (H00 to H63)(0 to 99)H0 (fixed)COM port selection(upper 4 bits) H1 H2 HF HEPort number COM1 COM2 COM0 Port number specified for the F469 (UNITSEL)instruction8.1 Communication InstructionWUME-FP0HCOM-06 8-25