Panasonic AW-RP555N Operating Instructions Manual

Contents

Panasonic AW-RP555N Operating Instructions Manual Manual pdf 18 page image

18OperationTurning on the power1. Set all the power switches of the connected componentsand the power switch of the AC adapter to ON.2. Set this unit’s OPERATE switch to ON.Power will be supplied to the pan/tilt head systemconnected to this unit, and the camera’s initial settingswill be performed in sequence.When the pan/tilt head system is connected (or changed)and its power is turned on for the first time, the connectedcameras will be initialized. Upon completion of theinitialization, adjust or set the following items. After the itemsare adjusted or set, proceed to the section entitled “Settingthe travel range (limiters) of the pan/tilt head”.Once the adjustments are made, there is no need for anyre-adjustments unless changes are made to the pan/tilthead, camera or lens. (The items to the re-set or re-adjusteddiffer depending on the unit which is changed.)EXTERNAL CONTROL OUT settingSet this to ON when connecting the AW-DU600 dial upadapter to the control panel’s TO PAN/TILT HEAD 1/EXTconnector. Normally, set it to OFF.1. Press the LAMP button while holding down theMEMORY button.2. The LAMP button’s lamp starts flashing, and the standbystatus is established.3. Press the LAMP button to establish the setting mode.The lamps of both the MEMORY button and LAMPbutton start flashing, and the status currently set isindicated as follows:When the PRESET 5 button lamp is lighted:EXTERNAL CONTROL OUT ONWhen the PRESET 10 button lamp is lighted:EXTERNAL CONTROL OUT OFF4. Press the PRESET 5 button to set to EXTERNALCONTROL OUT ON.Press the PRESET 10 button to set to EXTERNALCONTROL OUT OFF.The lamps of both the MEMORY button and LAMPbutton stop flashing, and the setting mode is exited. It takes about 5 seconds to perform the camera’sinitial settings for each camera. The pan/tilt headsystem cannot be controlled until these settings arecompleted. Be sure to set power switches on all connectedequipment and AC adapters to ON before settingthe control panel’s OPERATE switch to ON.