Panasonic AJ-PD500P Operating Instructions Manual

Contents

Panasonic AJ-PD500P Operating Instructions Manual Manual pdf 46 page image

46 Main Mode: Thumbnail Screen1) Write protected markThe mark is displayed when a P2 card is write pro-tected.2) P2 card statusWhen the remaining free space is displayed, the re-maining free space on the P2 card is indicated in theform of a bar meter and as a percentage value.When the used space is displayed, the used space onthe P2 card is indicated in the form of a bar meter andas a percentage value.The following may also be displayed depending oncard status.3) Remaining free space (or used space) and totalspace on the P2 cardIndicates the remaining free space (or used space)and total space on the P2 card in minutes. Fractions ofa minute are rounded off on the display so the sum to-tal of the remaining free space (or used space) oneach P2 card may not tally with the figure for the totalspace.4) Total slot free space (or used space)Indicates the value obtained by calculating the total ofthe remaining free space (or used space) on both P2card slots.Note:Free space of write protected P2 cards is not included in thefree space total.5) P2 card details displayAlign the cursor with a slot in the P2 card status displayand press the [SET] button to display the model num-ber and other detailed information on the card.Press the [SET] button again or the [EXIT] button toclose the detailed information screen.Note:If the number of clips recorded on a P2 card exceeds the limit,“OVER MAX NUMBER CLIPS” is displayed in the P2 card de-tails display to indicate that the limit has been exceeded.6) Card warning markThis warning is displayed for a P2 card in the followingcases.You can check the warning details in the P2 card de-tails display.• [RUN DOWN CARD]The maximum number of overwrites for a P2 cardhas been exceeded.• [DIR ENTRY NG]The P2 card directory structure is not supported.microP2 memory cards in an encrypted format are authenti-cated automatically by the unit, and can be used if authenti-cation is successful.If a microP2 memory card in a different encrypted format is in-serted in a card slot of a device authenticated with a differentCPS password, an authentication error occurs. To temporarilyuse the card for which the authentication error occurred, fol-low the procedure described in steps 1 and 2 to manually en-ter the authentication code (CPS password) for the microP2memory card. If the code matches, you will be able to use thatcard.1 Check the authentication failure.Open the thumbnail screen and select the “CARD STA-TUS” (➝ page 82) menu item to check the information.For a card with an authentication error, the slot numberframe at the top right of the screen turns red and the re-maining free space bar displays “AUTH NG CARD.” Usethe up or down cursor button to select that card.2 Perform manual authentication.Select the “AUTHENTICATE” (➝ page 83) menu item inthe card status screen to display the software keyboard forentering the CPS password.Enter the password and select “OK.”When CPS password input is successful, the “AUTHENTI-CATED SUCCESSFULLY!” message appears.When CPS password input fails, a warning message (➝page 116) appears.Note:• Manual authentication is only temporary. The manually setCPS password becomes invalid when the correspondingmicroP2 memory card is removed or the power is turned off.• Up to 16 characters can be entered for the CPS password.• For the conditions under which manual authentication is val-id and other information, refer to the website. (➝ “WebsiteURL” page 8)FORMAT ERROR!: An unformatted P2 card is in-serted.NOT SUPPORTED!: A card that is not supported bythe unit is inserted.NO CARD!: No P2 card is inserted.AUTH NG CARD: A microP2 memory card forwhich the CPS password can-not be authenticated is insert-ed.Manual and Automatic CPSAuthenticationManual CPS authentication