|
For Long and Trouble-Free Operation: Warning System 111For Long and Trouble-Free OperationWhen a warning occurs, a message is displayed on the OSD display and information display.Error CodesCode No. Displayed message Description OperationE-30 TURN POWER OFFDisplayed when an error occurs in reading and writing carddata.To continue operation, turn the power off and then back on.Card removalerrorE-31 TURN POWER OFFSystem mode errorTo continue operation, turn the power off and then back on. System errorE-35 SYSTEM ERRORCODEC microprocessor errorTo continue operation, turn the power off and then back on. System errorE-36 SYSTEM ERRORP2CS microprocessor error (error notification)To continue operation, turn the power off and then back on. System errorE-37 SYSTEM ERRORP2CS microprocessor error (communication disconnected)To continue operation, turn the power off and then back on. System errorE-39 SYSTEM ERRORVideo initialization errorTo continue operation, turn the power off and then back on.VideoinitializationerrorE-50 INPUT DC TOO LOW Displayed when the input DV voltage is below the undercutvoltage. Low voltageE-55OPT SYS ERRORDisplayed when an error occurs with the system of theAVCHD codec board AJ-YCX500G (option). To continue op-eration, turn the power off and then back on. System errorDisplay of warning informationDisplayed message Description Deck operationCANNOT RECDisplayed when data cannot be recorded on a P2 card.[Cause]• The card is write protected.• No more free space on the card.• Recording was attempted on a card that cannot be used.• Card status changed during recording.• Recording was attempted when the unit was BUSY.STOPCANNOT LOOP RECDisplayed when data cannot be recorded to a P2 card while the “RECORD-ING” (➝ page 86) menu item is “LOOP.”[Cause]• The card is write protected.• No more free space on the card.• Recording was attempted on a card that cannot be used.• Card status changed during recording.• Recording was attempted when the unit was BUSY.STOP
|
