Panasonic AJ-PD500P Operating Instructions Manual

Contents

Panasonic AJ-PD500P Operating Instructions Manual Manual pdf 22 page image

22 Preparation: P2 CardsP2 CardsNote:“FORMAT ERROR!” or “NOT SUPPORTED!” may appear if a microP2 memory card is inserted slowly. Should this happen, reinsert it.The unit supports separately sold P2 memory cards and microP2 memory cards of 4 GB to 64 GB. (As of October 2013)Note:• When AVC-Intra100 of 1080/60P and 1080/50P is selected, recording to the following P2 cards is not possible.- H, R, A, and E series P2 memory cards.• AJ-P2C002SG (2 GB) cards cannot be used.• The unit may need to be updated depending on the type of P2 card.• For the latest information not available in the Operating Instructions, visit the website. (➝ “Website URL” page 8)P2 Card Access Lamp and P2 Card StatusP2 Card Access Lamp P2 Card StatusLights green Recording possible Both writing and reading are possible.Lights orange Recording target Writing and reading are enabled and currently recording target.Flashing orange Card being accessed Writing or reading is in progress.Fast flashing orange Card being recognized The P2 card is being recognized.Slow flashing green Card full There is no available space on the P2 card. Only reading is possible.Write protected The write-protect switch on the P2 card is set to Protect. Only reading is pos-sible.Card not supported for re-cordingRecording is not possible with the currently set recording format because anSD memory card or other unsupported card is inserted. To record, changethe recording format or use a P2 card.Slot not target for record-ingA card has been inserted in a different slot from that of "REC MEDIA" (P2/microP2) (➝ page 87) of the "REC/PB SETUP" menu item.Off Card not supported The card cannot be used with the unit. Replace the card.Format invalid The P2 card is not formatted properly. Reformat it.No card A P2 card is not inserted. Waiting for the card to be recognized.Card cannot be authenti-catedA micorP2 memory card for which authentication is not possible. Refer to“Manual and Automatic CPS Authentication” (➝ page 46) and then performauthentication.No USB access The P2 card is not accessible using USB device mode.P2 Card Recording TimesP2 cards supported by the unit