252. Projecting an Image (Basic Operation) Turning off the ProjectorTo turn off the projector:1. First, press the (POWER) button on the projectorcabinet or the POWER OFF button on the remote con-trol.The [POWER OFF / ARE YOU SURE ? / CARBON SAV-INGS- SESSION 0.000[g-CO2]] message will appear.2. Secondly, press the ENTER button or press the(POWER) or the POWER OFF button again.The lamp will turn off and the projector will go into standbymode. When in standby mode, the POWER indicator willlight orange and the STATUS indicator will light green when[NORMAL] is selected for [STANDBY MODE].Power OnSteady blue lightStandbySteadyorange lightPress twiceCAUTION:Parts of the projector may become temporarily heated if the projector is turned off with the POWER button or if theAC power supply is disconnected during normal projector operation.Use caution when picking up the projector.NOTE:• While the POWER indicator is blinking blue in short cycles, the power cannot be turned off.• You cannot turn off the power for 60 seconds immediately after turning it on and displaying an image.• Wait at least 20 minutes after the power is turned on (after starting to project) before turning the AC power off while an image isbeing projected or while the cooling fan is running.• Do not unplug the power cord from the projector or from the power outlet while an image is being projected. Doing so coulddeteriorate the projector’s AC input connector or the power plug’s contact. To turn off the AC power while an image is beingprojected, use the power strip’s switch, the breaker, etc.• Do not disconnect the AC power supply to the projector within 10 seconds of making adjustment or setting changes and closingthe menu. Doing so can cause loss of adjustments and settings.
