71. IntroductionTerminal Panel Features1. HDMI 1 IN Connector (Type A)(→ page 144, 145, 149)2. HDMI 2 IN Connector (Type A)(→ page 144, 145, 149)3. DisplayPort IN Connector(→ page 144)4. BNC IN [R/Cr/CV, G/Y/Y, B/Cb/C, H, V] Connec-tors (BNC × 5)(→ page 143, 148)5. BNC (CV) Input Connector (BNC × 1)(→ page 143, 148)6. BNC (Y/C) Input Connector (BNC × 2)(→ page 143, 148)7. BNC AUDIO IN Mini Jack (Stereo Mini)(→ page 143, 148)8. COMPUTER IN/ Component Input Connector(Mini D-Sub 15 Pin)(→ page 13, 143, 148)9. COMPUTER AUDIO IN Mini Jack (Stereo Mini)(→ page 143, 148)10. Ethernet/HDBase T Port (RJ-45)(→ page 150)11. USB-A Port (Type A)(→ page 60)(Not available on PA722X/PA622X/PA672W/PA572W/PA622U/PA522U)12. HDMI OUT Connector (Type A)(→ page 144, 145, 149)13. AUDIO OUT Mini Jack (Stereo Mini)(→ page 146)14. 3D SYNC Connector (Mini DIN 4 Pin)(→ page 147)2 3112 8 910 11745 15 1613 14 615. PC CONTROL Port (D-Sub 9 Pin)(→ page 219)Use this port to connect a PC or control system.This enables you to control the projector using serialcommunication protocol. If you are writing your ownprogram, typical PC control codes are on page 219.16. REMOTE Connector (Stereo Mini)Use this connector for wired remote control of theprojector using the NEC optional remote control.Connect the projector and optional remote controlusing a commercially available wired remote controlcable.NOTE: When a remote control cable is connected to the RE-MOTE connector, infrared remote control operations cannotbe performed.
