1446. Installation and ConnectionsDisplayPort INHDMI 1 INHDMI 2 INDigital RGB signal connection• Connect a commercially available HDMI cable between the computer’s HDMI output connector and the projector’sHDMI input connector.• Connect a commercially available DisplayPort cable between the computer’s DisplayPort output connector andthe projector’s DisplayPort input connector.• Select the source name for its appropriate input connector after turning on the projector.NOTE:• Turn off the power of the computer and projector before connecting.• Lower the computer’s volume setting before connecting an audio cable to the headphones connector. When using with a computerconnected to the projector, adjust the volume of both the projector and computer to set the appropriate volume level.• If the computer has a mini-jack type audio output connector, we recommend connecting the audio cable to that connector.• This projector does not support NEC video unit (model ISS-6020) video decoded outputs.• When a video deck is connected via a scan converter, etc., the display may not be correct during fast-forwarding andrewinding.TIP• The Computer 1 and Computer 2 video input connectors support Windows Plug and Play. The Computer 3 video input connectordoes not support Windows Plug and Play.• A Macintosh signal adapter (commercially available) may be required to connect a Macintosh computer.To connect a Macintosh computer equipped with a Mini DisplayPort to the projector, use a commercially available Mini DisplayPort→ DisplayPort converter cable.HDMI cable (not supplied)DisplayPort cable (not supplied)
