NEC MultiSync MT1055 User Manual

Also see for LCDMT1050: Installation data Installation data Installation data

Contents

NEC MultiSync MT1055 User Manual Manual pdf 40 page image

E – 37[Page4]Auto Adjust (RGB Only):When "Auto Adjust" is set to "On", the projector automatically de-termines the best resolution for the current RGB input signal toproject an image using NEC's Advanced AccuBlend Intelligent PixelBlending Technology.The image can be automatically adjusted for position and stability;"Horizontal Position", "Vertical Position", "Clock", "Phase", and"Resolution."On ................ Automatically adjusts image "Horizontal Position", "VerticalPosition", "Clock", "Phase" and "Resolution".Off ................ User can adjust the image display functions ("Horizontal Po-sition", "Vertical Position", "Clock", "Phase" and "Resolution")manually.Auto Start:Turns the projector on automatically when the power cable is in-serted into an active power outlet. This eliminates the need to al-ways use the "Power" button on the remote control or projector cabi-net.Power Management:When this option is on and there is no RGB input for five minutes ormore, the projector will automatically turn itself off.Power Off Confirmation:This option determines whether a confirmation dialog for turning offthe projector will appear or not.NOTE: When the confirmation message is displayed, you must be in theProjector mode to operate your projector using the remote control. If not,press the PJ button on the remote control to change your projector to theProjector mode. The button lights to indicate that you are in the Projectormode.Keystone Save:This option enables you to save your current keystone settings.Saving your change once affects all sources. The changes are savedwhen you turn off the projector.Fan High Speed Mode:This option allows you to select two modes for fan speed: high-speed mode and normal speed mode.When you wish to cool down the temperature inside the projectorquickly, check this box. This is convenient especially when the pro-jector is installed on the ceiling.Auto Mute for Built-in Speaker:This option allows you to mute the built-in speakers automaticallywhen you connect an audio cable to the AUDIO OUT terminal.Clear Lamp Hour Meter:Resets the lamp clock back to zero. Pressing this button appears aconfirmation dialog box. To reset the lamp usage hour, press "OK".NOTE: The projector will turn off and go into standby mode after 1600 hours(up to 2600 hours in Eco mode) of service. If this happens, press the "Help"button on the remote control for ten seconds to reset the lamp clock backto zero. Do this only after replacing the lamp.[Page5]Remote Sensor:This option determines which remote sensors on the projector areenabled in wireless mode.The options are: front, rear, right, or left. All checked boxes indicatethat they can accept the infrared signal from the supplied remotecontrol.S-Video Mode Select:This feature is used to select the S-Video signal detection mode.This allows identifying of the S-Video signals with different aspectratio (Zoom signal 16:9, Wide Zoom signal 4:3).S2 ............... Identifies Zoom or Wide Zoom signal.OFF ............. Does not identify any S-video signal.RGBOUT Terminal:This option allows you to determine which RGB source is outputfrom the RGBOUT terminal when the Video, S-Video or Viewersource is selected.Disable ......... Neither RGB 1 nor RGB 2 is output from the RGBOUT termi-nal.RGB 1 .......... The signal from RGB 1 is output from the RGBOUT terminal.RGB 2 .......... The signal from RGB 2 is output from the RGBOUT terminal.NOTE: The AUDIO OUT mini jack outputs sound for the source that theprojector currently selects independently of setting "RGB OUT Terminal".