NEC MultiSync MT1055 User Manual

Also see for LCDMT1050: Installation data Installation data Installation data

Contents

NEC MultiSync MT1055 User Manual Manual pdf 22 page image

E – 19MENUENTERCANCELSELECTPOWERSTATUSON/STAND BYSOURCEAUTO ADJUSTAC INS-VIDEOVIDEOAUDIORGB INPUT 2AUDIORGB INPUT 1L /MONORAUDIORGB MONITOROUTPUTUSBPC-CARDC CONTROL MOUSEOUT REMOTCONTRINPUS-VIDEOVIDEOAUDIORGB INPUT 2AUDIORGB INPUT 1L / MONORAUDIORGB MONITOROUTPUTRGB INPUTAUDIOIBM VGA or Compatibles (Notebook type)RGB signal cable (supplied)To mini D-Sub 15-pin connector on theprojector. It is recommended that youuse a commercially available distribu-tion amplifier if connecting a signalcable longer than the supplied one.IBM VGA or Compatibles (Desktop type)Audio cable (not supplied)Connecting Your PCConnecting your PC to your MultiSync MT1055 and MT1050 (XGA)/MT850 (SVGA) projector will enable you to project your computer’sscreen image for an impressive presentation.To connect to a PC, simply:1. Turn off the power to your projector and computer.2. Use the supplied signal cable to connect your PC to the projector.3. Turn on the projector and the computer.4. If the projector goes blank after a period of inactivity, it may be causedby a screen saver installed on the computer you’ve connected to theprojector.