NEC MultiSync MT1055 User Manual

Also see for LCDMT1050: Installation data Installation data Installation data

Contents

NEC MultiSync MT1055 User Manual Manual pdf 21 page image

E – 18PC CONTROL REMOTECONTROLINPUTMOUSEOUTPUTS-VIDEO VIDEOAUDIO RGB INPUT 2AUDIO RGB INPUT 1L / MONO RAUDIO RGB MONITOROUTPUTWiring DiagramNOTE: When using with a notebook PC, be sure to connect between the projec-tor and the notebook PC before turning on the power to the notebook PC. Inmost cases signal cannot be output from RGB output unless the notebook PCis turned on after connecting with the projector.NOTE: If using video, S-video, or audio cables, the cables should be 3 m (9.8feet) or shorter.Remote Control Guideline for the Remote Control1. Plug the supplied serial cable with the mouse output port of the pro-jector into your computer’s mouse port and restart your computer togain remote mouse control.2. When using the remote control’s built-in infrared mouse on a laptopcomputer, the laptop’s mouse, trackball or trackpad will be disabled.Disconnect the serial cable from the mouse output port and restartyour computer to regain trackball or trackpad mouse control.3. If the screen goes blank while using your remote control, it may bethe result of the computer’s screen-saver or power managementsoftware.4. If you accidentally hit the OFF button on the remote control, wait onefull minute and then press the ON button to resume.Supplied serial cableSupplied mouse adapter(For Macintosh or USB)Supplied mouse adapter(For IBM PS/2 or USB)Macintosh or Compatibles(Desktop type or notebook type)IBM VGA or Compatibles(Desktop type or notebook type)Signal cable (supplied)To mini D-Sub 15-pin connector on theprojector. It is recommended that youuse a commercially available distribu-tion amplifier if connecting a signalcable longer than the supplied one.DVD Player (with component output)Optional Component V cableDocument CameraTo video, S-video, and audioinputs on the projector.VCR, DVD Player or LaserDisc PlayerMonitorConnecting Your PC or Macintosh ComputerConnecting your PC or Macintosh computer to your MultiSync MT1055and MT1050 (XGA) / MT850 (SVGA) projector will enable you to projectyour computer’s screen image for an impressive presentation.To connect to a PC or Macintosh, simply:1. Turn off the power to your projector and computer.2. Use the signal cable that’s supplied to connect your PC or Macintoshcomputer to the projector.NOTE:The new Macintosh computer such as G3 will have the 15 pin HDconnector. The MT1055/MT1050/MT850's "Plug and Play" data will be down-loaded to the Macintosh. Therefore, the Mac adapter will not be necessary.3. Turn on the projector and the computer.4. If the projector goes blank after a period of inactivity, it may be causedby a screen saver installed on the computer you’ve connected to theprojector.