NEC MultiSync MT1055 User Manual

Also see for LCDMT1050: Installation data Installation data Installation data

Contents

NEC MultiSync MT1055 User Manual Manual pdf 11 page image

E – 81. Source ButtonUse this button to select a video source such as a PC, VCR, DVDplayer or PC Card Viewer (PC card).Each time this button is pressed, the input source will change as fol-lows:→ RGB1 → RGB2 → Video → S-Video → PC Card Viewer If no input signal is present, the input will be skipped.2. Auto Adjust Button (RGB only)Use this button to adjust Position-H/V and Pixel Clock/Phase for anoptimal picture. Some signals may not be displayed correctly or taketime to switch between sources.3. Menu ButtonDisplays the menu.4. Select st ß © / Volume (+) (-) Buttonsst: Use these buttons to select the menu of the item you wish toadjust.When no menus appear, these buttons work as a volume con-trol.ß ©: Use these buttons to change the level of a selected menu item.A press of the © button executes the selection.When the menus or the Viewer tool bar is not displayed, thesebuttons can be used to select a slide, or to move the cursor inFolder List or Slide List.When the pointer is displayed, these st ß © buttons movethe pointer.5. Enter ButtonExecutes your menu selection and activates items selected from themenu.Top Features6. Cancel ButtonPress this button to exit "Menus". Press this button to return the adjust-ments to the last condition while you are in the adjustment or settingmenu.7. Status IndicatorWhen this is lit red (orange in Eco mode) continually, it's warning youthat the projection lamp has exceeded 1500 hours (2500 hours in Ecomode) of service. After this light appears, it is advisable to replace theprojection lamp as soon as possible. (See page E-47). In addition themessage "The lamp has reached the end of its usable life. Please re-place the lamp." appears continually until the lamp is replaced.If this light blinks red rapidly, it indicates that the lamp cover is notattached properly or the projector is overheated.See the Power / Status Light Messages on page E-49 for more details.8. Power Indicator ( )When this indicator is green, the projector is on; when the indicator isorange, it is in standby mode.9. Power Button (ON / STAND BY)Use this button to turn the power on and off when the power is sup-plied and the projector is in standby mode.NOTE: To turn off the projector, press and hold this button for a minimum oftwo seconds.MENUENT E RCANCELSELECTPOWERSTATUSON /STAND BYSOURCE AUTO ADJUST157823469