765. Using On-Screen MenuEnabling Direct Power On [DIRECT POWER ON]Turns the projector on automatically when the power cord is inserted into an active power outlet. This eliminates theneed to always use the POWER button on the remote control or projector cabinet.Turning On the Projector By Applying Computer Signal [AUTO POWER ON]When the projector is in Standby mode, applying a computer or HDMI signal from a computer connected to the COM-PUTER IN input, HDMI1, or HDMI2 input will power on the projector and simultaneously project the image.This functionality eliminates the need to always use the POWER button on the remote control or the projector cabinetto power on the projector.To use this function, first connect a computer to the projector and the projector to an active AC input.NOTE:• Disconnecting a computer signal from the computer will not power off the projector. We recommend using this function in com-bination of the AUTO POWER OFF function.• This function will not be available under the following conditions:- when a component signal is applied to the COMPUTER IN terminal- when a Sync on Green RGB signal or composite sync signal is applied• To enable the AUTO POWER ON after turning off the projector, wait 5 seconds and input a computer or HDMI signal.If a computer or HDMI signal is still present when the projector is turned off, the AUTO POWER ON will not work and the projectorremains in standby mode.• Depending on the projector in use, the AUTO POWER ON may not work properly. In this case, set [STANDBY MODE] to [NETWORKSTANDBY].Enabling Power Management [AUTO POWER OFF]When this option is selected you can enable the projector to automatically turn off (at the selected time: 0:05, 0:10,0:15, 0:20, 0:30, 1:00) if there is no signal received by any input or if no operation is performed.
