Lenovo RackSwitch G8264 Command Reference Manual

Also see for RackSwitch G8264: Installation guide Product guide Product guide Application guide Installation guide

© Copyright Lenovo 2017 Appendix A: Enterprise NOS System Log Messages 751LOG_ERRThread LOG_ERR MessageCFG Canʹt assign a port with same protocol to different VLANs.CFG Configuration file is EMPTYCFG Configuration is too largeCFG Default VLAN and management VLAN cannot beprivate‐VLANs.CFG Error writing active config to FLASH! Configuration is too largeCFG Error writing active config to FLASH! Unknown errorCFG ERROR: Cannot enable/disable RMON for Mgmt Port CFG ERROR: More than VLAN(s) in downstreamCFG Error writing active config to FLASH! Another save is in progressCFG Maximum allowed number (30) of Alarm groups have alreadybeen created.CFG Maximum allowed number (30) of Event groups have alreadybeen created.CFG Maximum allowed number (5) of History groups have alreadybeen created.CFG Need to enable portʹs tag for tagging pvlan.CFG Overflow! Port has more than 16 protocols.CFG Port is not for this protocol.CFG Switch rem port fails when disable {protocol|vlan}.CFG TFTP {Copy|cfgRcv} attempting to redirect a previouslyredirected outputCFG WARN: Have not defined protocol type for VLAN Protocol !DCBX Duplicate DCBX Application Protocol Sub‐TLV detected on portDCBX Duplicate DCBX Control Sub‐TLV detected on port DCBX Duplicate DCBX PFC Sub‐TLV detected on port DCBX Duplicate DCBX PG Sub‐TLV detected on port DCBX Duplicate DCBX VNIC Sub‐TLV detected on port ETS The internal COS7 is used for stack communication; hence the ETSpriority group 7 is not available.