Lenovo RackSwitch G8264 Command Reference Manual

Also see for RackSwitch G8264: Installation guide Product guide Product guide Application guide Installation guide

556 G8264 Command Reference for ENOS 8.4OSPFv3 Virtual Link ConfigurationThe following table describes the OSPFv3 Virtual Link commands.Table 294. OSPFv3 Virtual Link Configuration OptionsCommand Syntax and Usagearea virtual link <1‐3> area <0‐2>Configures the OSPF area index.Command mode: Router OSPF3area virtual link <1‐3> dead interval <1‐65535>Configures the time period, in seconds, for which the router waits for hellopacket from the neighbor before declaring this neighbor down.Command mode: Router OSPF3[no] area virtual link <1‐3> enableEnables or disables OSPF virtual link.Command mode: Router OSPF3area virtual link <1‐3> hello interval <1‐65535)>Configures the indicated interval, in seconds, between the hello packets, thatthe router sends on the interface.Command mode: Router OSPF3area virtual link <1‐3> neighbor router router ID (IP address)>Configures the router ID of the virtual neighbor.The default setting is 0.0.0.0.Command mode: Router OSPF3area virtual link <1‐3> retransmit interval <1‐1800>Configures the interval, in seconds, between link‐state advertisement (LSA)retransmissions for adjacencies belonging to the OSPFv3 virtual link interface.The default value is 5 seconds.Command mode: Router OSPF3area virtual link <1‐3> transmit delay <1‐1800>Configures the estimated time, in seconds, taken to transmit LS update packetover this interface.Command mode: Router OSPF3no area virtual link <1‐3>Deletes OSPF virtual link.Command mode: Router OSPF3show ipv6 ospf area virtual linkDisplays the current OSPFv3 virtual link settings.Command mode: All