Settings and Operation of the CameraRecorder1 Set to Camera mode.(A P18 [Operation Modes] )2 Set [TC/UB] B [TC Generator] as follows.0 Slave device:Select “Free Run(Ext)”.0 Master device:Select “Free Run”.3 Set LCD monitor or viewfinder to Display 1screen.4 Set the master device and run the timecode.0 When the built-in time code generator issynchronized with the external time codedata input, the Z icon on Display 1 screenlights up.0 When time code is not synchronized or timecode input is not available, the Z icon goesout..P13000K 1/ 100F1.60dBAE+6ND 1 /6412 :34 :56Jan 24,201200: 00: 00.004030 20 10 05 . 6f tMemo :0 The built-in time code generator will continueoperation even when the master device isdisconnected after synchronization.0 User’s bit will become data in the master device.0 While the [TC] terminal is connected, the timecode may be out of synchronization when the[A/V Set] B [Video Set] B [HDMI/SDI Out]setting of the Master device and Slave device isbeing changed.(A P111 [ HDMI/SDI Out ] )Setting Zebra PatternWhen the luminance level range for displayingzebra patterns is specified, diagonal lines (zebrapattern) are displayed at areas with the specifiedluminance levels during shooting..AE LEVELPUSH AUTOZEBRA/51 Set the zebra display pattern.Select the display pattern in [LCD/VF] B[Shooting Assist] B [Zebra].2 Specify the brightness (luminance) levelrange for displaying zebra pattern.Specify the upper and lower limits of theluminance level in [LCD/VF] B [ShootingAssist] B [Zebra] B [Top] and [Bottom].Item Settings OptionsTop Upper luminancelimit for displaying[Zebra]5% - 100%, Over(in 5 % increments)Bottom Lower luminancelimit for displaying[Zebra]0% - 100% (in 5 %increments)3 Display the zebra pattern.Press the [ZEBRA/5] button to display the zebrapattern in the specified range..Memo :0 “Zebra” is assigned to [ZEBRA/5] button infactory default.0 “Zebra” can also be assigned to other userbuttons.(A P38 [Assignment of Functions to UserButtons] )71Shooting
