Settings and AdjustmentsBefore Use.Adjusting the Grip BeltOpen the pad and adjust the position of the grip beltaccordingly..AUXINPUT2INPUT1DEVICEAVABATT.RELEASEPOWER/CHGBHDMIREMOTEDCHD/SDSDIRECHOSTCaution :0 If the grip is loose, the camera recorder may falloff resulting in injuries or malfunction.Attaching an External MicrophoneYou can attach a separately sold microphone to themicrophone holder..451, 321 Turn the knob on the microphone holderanticlockwise to loosen and open themicrophone holder.2 Place the microphone in the microphoneholder.3 Turn the knob on the microphone holderclockwise to secure the microphone.4 Connect the microphone cable to the[INPUT1] or [INPUT2] terminal.5 Pin the microphone cable to the clamp.6 Perform the settings for the microphonecorrectly.(A P63 [Audio Recording] )Attaching the TripodUse the screw hole at the bottom of this camerarecorder.(3/8×16UNC, 1/4×20UNC)Use the screw hole that suits the tripod.To prevent the camera recorder from falling off,which may result in injuries or damages, read theinstruction manual of the tripod to be used andmake sure that it is securely attached..o BottomCaution :0 Use the tripod on a stable surface.0 To prevent the camera recorder from falling,attach securely using the rotation preventionhole.0 Use screws with screw length 5 mm and below.Attaching the Large Eyecup0 Attach the large eyecup (supplied) to preventexternal light from entering the viewfinderscreen and cameraman’s vision.0 Align and attach to the groove of the eyecupmounted on the camera recorder.0 The large eyecup can be attached in anydirection..Large Eyecup (supplied)EyecupMemo :0 Do not remove the eyecup that is premountedon the camera recorder.27Preparations
