Setting Input Channel to [INPUT1]/[INPUT2]Select the audio to input to [INPUT1] and [INPUT2]terminals with the [INPUT1]/[INPUT2] modeswitch.Setting Description[LINE] Use this setting when connecting toan audio device or other equipment.The reference input level is +4 dBu.[MIC] Use this setting when connecting toa dynamic microphone.[MIC+48V] Use this setting when connecting toa microphone (phantommicrophone) that requires a +48 Vpower supply.Memo :0 When “MIC” or “MIC+48V” is selected, set thereference input level in [Main Menu] B [A/VSet] B [Audio Set] B [Input1 Mic Ref.]/[Input2Mic Ref.].(A P112 [ Input1 Mic Ref. ] )(A P112 [ Input2 Mic Ref. ] )Caution :0 When connecting a device that does not requirea +48 V power supply, make sure that it is notset to the “MIC+48V” position.0 When the [INPUT1]/[INPUT2] mode switch isset to “MIC”, make sure that a microphone isconnected to the [INPUT1]/[INPUT2] terminal. Ifyou increase the recording level when amicrophone is not connected, noise from theinput terminal may be recorded.0 When a microphone is not connected to the[INPUT1]/[INPUT2] terminal, set the [INPUT1]/[INPUT2] mode switch to “LINE” or adjust thevolume with the [CH1]/[CH2] recording leveladjustment knob.Adjusting Audio Recording LevelYou can select to adjust the audio recording levelsfor the two channels (CH1/CH2) manually orautomatically..FULL AUTOONOFFCH1INTINPUT1INPUT2AUTOMANUALCH2LCCH2CH1Manual Adjustment Mode (ManualAdjustment)0 Set the [CH1/CH2 AUTO/MANUAL] switch onthe camera recorder to “MANUAL” to enter themanual adjustment mode, and use the [CH1]/[CH2] recording level adjustment knob to set therecording level.0 You can adjust the level manually during therecording, recording standby, and stop modes.o Setting Input Channel to “INPUT1”/“INPUT2”1 Set the [CH1/CH2 AUTO/MANUAL]selection switch to “MANUAL” for thechannel to be adjusted manually.2 Turn the corresponding [CH1]/[CH2]recording level adjustment knob to adjustthe level.When [Audio Set] B [Limiter] is set to “Off”,adjust such that the audio level meter does notlight up at -2 dB even for loud sounds.(A P112 [ Limiter ] ).P13000K 1/ 100F1.60dBAE+6ND 1 /6412 :34 :56Jan 24,201200: 00: 00.004030 20 10 05 . 6f t4030 20 10 0-2dB64Shooting
