Camera Function MenuMenu screen for specifying operation settingsduring shooting.This item can only be selected in the Cameramode.BarsFor setting whether to output color bars.[Setting Values: On, ROff]Memo :0 The audio test signals (1 kHz) can be outputsimultaneously with the color bar output.(A P111 [ Test Tone ] )OISFor setting whether to enable image stabilizer.When “On” is selected, set the Level.[Setting Values: On, ROff]9 LevelFor setting the level of the image stabilizer.[Setting Values: High, RNormal]Memo :0 When “High” is selected, correcting severecamera shake may cause the area surroundingthe image to darken.Flicker CorrectionFor setting whether to adjust image flicker thatoccurs under a fluorescent light.[Setting Values: On, ROff]Flash Band CorrectionFor reducing the condition of the flash bandphenomenon, which creates an unnatural imagewith a part of it brightly lit, such as by the cameraflash of another still camera.[Setting Values: On, ROff]Caution :0 Flash band correction function is not available inany of the following cases.0 When [Rec Mode] is set to “Variable Frame”0 When [WFrame & Bit Rate]/[YFrame & BitRate] is set to “24p(HQ)” or “24p(UHQ)”0 When in the Automatic Shutter mode or whenthe shutter is turned on in the Manual Shuttermode(A P54 [Manual Shutter Mode (Manual ShutterSwitching)] )0 When [Network] is set to “On(SDI Off)” or“On(HDMI Off)”0 [Flash Band Correction] operates when theluminance of the screen varies widely, with orwithout flash light. However, depending on theshooting condition, the flash band correctionmay not be fully effective even if there are flashlights.0 The following symptoms may occur under flashlight, but these are not malfunctions due to flashband correction.0 Moving object appears to be stationarymomentarily.0 A horizontal line appears on the image.0 The [Flash Band Correction] function will be setto “Off” if the camera recorder switches from theCamera mode to another mode, or when the[POWER ON/OFF(CHG)] switch is set to“OFF(CHG)”.ShutterFor specifying shutter-related settings.Use this item to set to “Step” (fixed value) or“Variable” when operating with the cross-shapedbutton (JK) on the right side.0 Variable:Sets to variable scan. Use this setting such aswhen shooting a PC monitor.0 Step:Sets to step shutter, which switches the shutterspeed by a fixed value.[Setting Values: Variable, RStep]AE LevelFor setting the convergence level during AE (AutoExposure).This can also be adjusted using the cross-shapedbutton (HI) on the right side.[Setting Values: -6 to +6 (R0)]AE SpeedFor setting the convergence speed during AE (AutoExposure).[Setting Values: RFast, Middle, Slow]96Menu Display and Detailed Settings
