Interval RecIn normal recording, when the recording stops, theimage and accompanying data from the start till theend of the recording are recorded as one “clip” onthe SD card.In this mode, recording and pause are performedrepeatedly at the specified time interval. Only thespecified number of frames is recorded.The recording can be written to the media as asingle clip until it is stopped.Memo :0 Audio will not be recorded.0 Until a specified amount of recordings isaccumulated, the file will not be written to themedia.0 After the specified number of frames is recordedand written to the media, recording will beperformed until the same number isaccumulated again.0 If the specified amount is not reached whenrecording is stopped, normal recording isperformed and frames are added to the endingof the clip until the amount is reached. (Padding).Specific amount of dataActual clips recorded to the mediaRecords number of frames specified in [Rec Frames](Padding data)Normal recordingPausePausePause[Rec Interval][Rec Interval]Recording resumesRecording resumes(Interval Rec stops)(Interval Rec starts)Press [REC]Press [REC]1 Set [Rec Mode] to “Interval Rec”.0 Set [Main Menu] B [System] B [RecordSet] B [Rec Mode] to “Interval Rec”.(A P117 [ Rec Interval ] )0 The display changes (“STBY”B“STBYN”).2 Set the number of frames to record in [RecFrames].Set using [Main Menu] B [System] B [RecordSet] B [Rec Mode] B [Rec Frames].(A P117 [ Rec Frames ] )3 Set the time interval to start recording in[Interval Rec].Set using [Main Menu] B [System] B [RecordSet] B [Rec Mode] B [Rec Interval].(A P117 [ Rec Interval ] )4 Start recording.0 Press the [REC] button to record only thenumber of frames specified in [RecFrames] and pause.0 After the specified time in [Rec Interval] haspassed, recording starts again to record onlythe number of frames specified in [RecFrames] and pause.0 Interval Rec continues until the recording isstopped.The display changes (“STBYN” B “RRECN”B “STBYN” (red text) B “RRECN” B“STBYN” (red text)).0 The card slot status indicator blinks in green.5 Press and hold the [REC] button.0 The card slot status indicator lights up ingreen.0 The display becomes “STBYN”.Caution :0 Do not remove the SD card during recording(RRECN, red text) or recording pause (STBYN,yellow text).0 To remove the SD card during Interval Rec,press the [CANCEL] button, check that “STBYN”(white text) is displayed and the card slot statusindicator lights up in green before you removethe card.0 When [Main Menu] B [TC/UB] B [TCGenerator] is set to “Free Run” or “FreeRun(Ext)”, the time code will be recorded in “RecRun”.0 Audio cannot be recorded. A x mark appearsin the audio level meter display.(A P127 [Audio Level Meter] )81Shooting
