Managing/Editing Clips ona PCLoading Clips to the PC (USBConnection Mode)0 You can load clips to a PC by connecting thecamera recorder to the PC via the USB port.Doing so enables clips stored in the SD card tobe managed and edited on the PC.0 Files on the SD card can be managed/edited onthe connected PC in this mode only for USBmass storage class devices that are recognizedby the said PC as a peripheral drive.Memo :0 Files cannot be written to the SD card.0 Make sure to manage/edit files recorded in theMP4 file format using the (JVC ProHD ClipManager) PC application software in thesupplied disc.0 For details on how to install the applicationsoftware, refer to the [User's Guide] of the [JVCProHD Clip Manager] inside the supplied disc.1 Connect the camera recorder to the PCusing a USB cable.A confirmation message “Change to USBMode?” to enable the USB connection appears. .AUXINPUT2INPUT1DEVICEAVABATT.RELEASEPOWER/CHGBHDMIREMOTEDCHD/SDSDIRECHOST AVDEVICEPC2 Select [Change] using the cross-shapedbutton (JK), and press the Set button (R).The camera recorder switches to USB mode. .2Memo :0 If recording is in progress, the “Change to USBMode?” message appears after recordingstops.0 If playback is in progress, the camera recorderswitches to USB mode after the file closesautomatically, such as when playback stops.Disconnecting0 Disable the connection on the PC, then removethe USB cable from the camera recorder.0 Doing so exits the USB mode and switches thecamera recorder to Camera mode.Memo :0 The procedure for disabling the USB connectionvaries according to the PC in use. For details,refer to the instruction manual of the PC.139Connecting External Devices
