H FrequencyFor specifying the correction frequency of thehorizontal contour. Set this according to the object.0 High:Emphasizes the high frequency range. Use thiswhen shooting objects with fine patterns.0 Middle:Emphasizes the intermediate frequency range.0 Low:Emphasizes the low frequency range. Use thiswhen shooting objects with large patterns.[Setting Values: High, RMiddle, Low]Memo :0 When [System] under [Record Format] is set to“SD”, this item is fixed at “Low”.0 When [System] under [Record Format] is set to“HD+SD”, this item can be set during HDrecording, but will be fixed at “Low” during SDrecording.V FrequencyFor specifying the correction frequency of thevertical contour. Set this according to the object.0 Low:Emphasizes the low frequency range.0 Middle:Emphasizes the intermediate frequency range.0 High:Emphasizes the high frequency range.[Setting Values: Low, RMiddle, High]Memo :0 When [System] under [Record Format] is set to“SD”, this item is fixed at “Low”.(A P114 [ Record Format ] )0 When [System] under [Record Format] is set to“HD+SD”, this item can be set during HDrecording, but will be fixed at “Low” during SDrecording.0 “High” cannot be selected under the followingsettings.0 When [WResolution] is set to “1920x1080”,and [WFrame & Bit Rate] is set to “60i(HQ)”or “50i(HQ)”.0 When [WResolution] is set to “1440x1080”,and [WFrame & Bit Rate] is set to “60i(HQ)”,“50i(HQ)”, “60i(SP)” or “50i(SP)”.Skin DetailFor turning On/Off the Skin Detail function, whichis used to adjust the contour correction effect of thecolors captured.Select “On” to soften the detail at areas where skintone is detected.[Setting Values: On, ROff]9 LevelFor setting the level of contour correction (degreeof softening) using the Skin Detail function.Decreasing the value increases the level of contourcorrection (degree of softening).[Setting Values: -1, R -2, -3]9 RangeFor adjusting the range of skin tone to trigger theSkin Detail function.Increasing the value increases the range.[Setting Values: -5 to +5 (R0)]White Balance ItemPreset Temp.For setting the color temperature when the [WHTBAL] switch is set to “PRESET”.For details, refer to “[Adjusting the WhiteBalance] P 57”.Alternative Temp.For setting the alternative color temperature in thePreset mode.When the [WHT BAL] switch is set to “PRESET”,pressing the [y] button each time switches thecolor temperature setting in the Preset mode.([Preset Temp.] 1 [Alternative Temp.])For details, refer to “[Adjusting the WhiteBalance] P 57”.103Menu Display and Detailed Settings
