Chapter 22-302.2.21 Switching Over the Paper Size forthe Front Deck (right, left) 0010-89971) Press the front deck release button, and slideout the deck.2) Remove the screw [2] of the rear guide plate[1], and fix the guide plate in place to match thesize specified by the user.F-2-1203) Remove the screw [2] from the left/right guideplate [1], and fix the guide plate in place tomatch the size specified by the user.F-2-1214) Put paper in the front deck.5) Close the front deck.6) Choose the appropriate deck size label [1] fromthe backing paper (cassette/deck), and attach itto the paper size plate of the deck.F-2-1227) Start service mode, and register the front deckpaper size.MEMO:right deck: COPIER > OPTION > CST > P-SZ-C1left deck: COPIER > OPTION > CST > P-SZ-C2A4=6, B5=15, LTR=188) When done, go through the shut-downsequence to turn off and then on the mainpower.2.2.22 Checking the Operation in aSystem Configuration 0011-42971) Install the accessories according to theirrespective Installation Procedures.2) Check to make sure that all accessories havebeen connected correctly.- Make a check in service mode:Start service mode, and make the followingselections: COPIER > OPTION > ACCPST-D > ACC1 through 8.Check to see that the order and the modelnames are indicated correctly.End service mode.- Click 'system status/stop' to check the deviceinformation.Check to make sure that all connectedaccessories are indicated.3) Check the operation using the accessories.- Make sure paper does not jam, move askew,or fail to deposit properly.[1][2][1][2][1]
