Chapter 88-408.11.10.4 Mounting the multiple curlingprevention roller 0010-90071) Set the multiple curling prevention rollerassembly to the main body.2) Mount the rear fixing plate 2 and the rear fixingplate 1 in the order indicated; then, secure themin place with the mounting screw [3].F-8-87When mounting the multiple curling preventionroller, hook the two claws of the rear fixing plate2 on the three holes in the rear side plate; then,mount the rear fixing plate 1 to secure.8.11.11 Manual Separation Roller8.11.11.1 Removing the Separation Roller0010-9031F-8-88When removing the separation roller, pay atten-tion to the bushing at the front.It will slip off.Initially, the urethane sponge of the part is pink,and changes over time (accelerated if exposed tolight).Its tone will change from pink to orange and toyellow; it is a general characteristic of urethanesponge, and no physical deterioration (in per-formance) exists because of changes in color, andthe part is not identified by color.F-8-898.11.12 Manual Feed Tray paper sensor8.11.12.1 Removing the Manual FeedTray Paper Sensor 0010-90321) Open the manual feed tray unit, and remove thedoor tape from the machine side.2) Remove the mounting screw [1], and detachthe solenoid cover [3]. (A claw [2] is hooked onthe L-shaped opening; pull it down lightly, andmove it as if to open it.)F-8-903) Disconnect the connector [1].4) Remove heater mounting screw [2], and detachthe pickup roller releasing solenoid [3] togetherwith the support plate.F-8-91Rear fixing plate 2[1][2][3][4][1]Urethane sponge pieces[1] [3][2][1][2][3]
