Chapter 1616-2216.3.3 Jam Code (DADF-M1) 0011-5509T-16-70085 error PI1,PI2,PI11A motor error other than an IPC communication or pickup error hasoccurred. (less than 3 times)0090 ADF open PI10 The ADF is identified as being open.0091 user DF open PI10 The ADF is identified as being open while the machine is operating.0092 cover open PI3,PI6 The cover is identified as being open.0093 user cover open PI3,PI6 The cover (front or rear) is identified as being open while the machine isoperating.0094 initial stationary PI4,PI12,PI13,S1,S2,S3,S4,S5,S9At the start of operation, a sensor inside the paper path detects an original.0095 cycle fault S6 The pickup signal has been received for a specific period of time (2 sec)in the absence of a detected original.0096 residual original S1 The reversal sensor detects an original while the belt motor is moved fora specific distance before the start of a left pickup job.0097 manual feederresidual originalS1,S9 At time of manual feed pickup, the reversal sensor detects an originalwhile the manual feeder registration roller sensor also detects an original.0098 power-down - A drop occurs in the voltage supplied by the host machine while themachine is operating.Code Sensor Notation Description0001 post-separation sensor PI7 The post-separation sensor does not detect paper when paperhas been moved 452 mm after the start of separation.0002 post-separation sensor PI7 - The separation sensor detects paper when paper has beenmoved 500 mm (if extra-length, +200 mm) -45.5 mm afterregistration pickup.- the sensor goes on (paper with hole) before paper has beenfed 12 mm after the detection of the trailing edge; theseparation sensor detects paper after paper has been fed 50mm from when the separation senor has gone on.0003 registration sensor PI1 The registration sensor does not detect paper a feed length of134.8 mm after the post-separation sensor has gone on.0004 registration sensor PI1 The read sensor goes off before the registration sensor goesoff.0005 read sensor PI8 - The read sensor does not detect paper a feed length of 364.2mm (182.1 x 2) from the point of registration.- The read sensor does not detect paper a feed length of 157.4mm (78.7 x 2) from the point of No. 2 registration.0006 read sensor PI8 - The read sensor detects paper a feed length of 500 mm (ifextra-length, +200 mm) after the start of feed, resumed aftera temporary stop for reading.- At time of LTRR/LGL identification in mix mode, the readsensor detects paper a feed length of 514 mm after the start offeed from the edging wait point.0007 delivery reversal sensor PI9 If not in high-speed duplexing mode, the delivery sensor doesnot detect paper when paper is moved 132.1 mm after it hasreached the leading edge lower stream roller with reference tothe activation of the read sensor.0008 delivery reversal sensor PI9 The delivery sensor detects paper a feed length of 161.9 mmafter the trailing edge read end point.0042 post-separation sensor PI7 1st sheet, post-separation sensor, stationary0043 registration sensor PI1 1st sheet, registration sensor, non arrivalCode Sensor type Sensor No. Description
