Canon imageRUNNER 3300 Series Manual

Also see for imageRUNNER 2200 Series: Guide Copying guide

Contents

Canon imageRUNNER 3300 Series Manual Manual pdf 42 page image

Settings Menu3-103Printer Settings Menu Functions and OperationOffset XOffset Y-2.00 - 0.0 - +2.00 inch (in increments of 0.01 inch)This setting sets the offset position in inch. The settings can be setbetween -2.00 inch (-50.0 mm) to +2.00 inch (+50.0 mm) in increments of0.01 inch (0.5 mm).The print position is adjusted in the vertical or horizontal direction only tothe value specified in the setting value.You can increase or decrease the setting in increments of 0.01 inch (0.5mm) to adjust the print position as described below.Offset X: Increasing the setting value moves the image in the X directionon the paper. Decreasing the setting value moves the image inthe X direction on the paper.Offset Y: Increasing the setting value moves the image in the Y directionon the paper. Decreasing the setting value moves the image inthe Y direction on the paper.IMPORTANT• Please note that if the print position is adjusted to placeprint data outside the valid print area, the portion outsidethe valid print area will not be printed.NOTE• Pressing [ ] increases the setting value by 0.01 inch(0.5 mm) each time the key is pressed. Pressing [ ]decreases the value by 0.01 inch (0.5 mm) each time.Holding down either [ ] or [ ] continuously speedsup the value alteration.DEFABCABC DEFX XY YAdjust usingX/Y-AdjustmentArea adjusted usingY-Adjustment[+]Area adjusted usingX-Adjustment[+]