Canon PIXMA MP950 User Manual

Also see for PIXMA MP950: Supplementary guide Start here Service manual

Contents

Canon PIXMA MP950 User Manual Manual pdf 135 page image

Chapter 12 133Troubleshooting*1 To resume printing, you can press [OK] on the machine instead of selecting Continue.Cannot Print Properly through WirelessCommunicationThe following are the causes of the trouble may occur when printing through infraredcommunication.For the trouble when printing through Bluetooth communication, refer to the Bluetooth User’s Guide.Printer error An error requiring servicing might have occurred.Disconnect the cable between the machine and the camera, turn off themachine, and unplug the power cord of the machine from the power supply.After a while, plug the power cord of the machine back in, turn on themachine, and then reconnect the camera to the machine. If the same erroroccurs, contact the Canon Customer Care Center.Cause ActionThe installation place, distance,and/or angle is improper.When printing through infrared communication, confirm that the infraredcommunication ports on both the machine and the mobile phone are placedto face each other at the proper angle and distance, and that there isnothing to block the communication between them, and then try printingagain. The proper distance and angle for communication vary dependingon the specifications of your mobile phone and on external environment.Place the machine within 7.87" / 20 cm from the mobile phone for propercommunication.During infrared communication,infrared rays were interrupted oranother infrared communicationdevice is operating nearby.If infrared communication between the infrared ports of the machine andthe mobile phone is interrupted by any obstacle for ten and severalseconds or longer during printing, the paper on which data is being printedis ejected and the machine is reset. Remove the obstacle and retry printing.If an infrared communication device is operating nearby, interference canoccur and fail in printing the document to the end. While printing adocument through infrared communication, do not operate another infraredcommunication device, such as a remote controller of a TV, nearby.The version of the infraredcommunication port being used isnot compatible with IrDA.The infrared communication function of the machine is only compatiblewith mobile phones with IrDA compliant infrared communication ports.Printing through infrared communication cannot be performed by any othertypes of mobile phones.Error Message On Camera Action