Chapter 990 Chapter 9Reading from and Writing to a Memory CardReading from and Writing to a MemoryCardSetting up the Card Slot as the Memory Card Drive ofthe ComputerThe Card Slot of the machine can also be used as the memory card drive of the computer.1 Display the Read/write attribute screen.(1) Ensure that the memory card is not set.If the memory card is set, remove it from the Card Slot. See “Inserting the Memory Card”on page 45.(2) Press [Menu].(3) Use [ ] or [ ] to select and then press [OK].(4) Use [ ] or [ ] to select and then press [OK].(5) Use [ ] or [ ] to select and then press [OK].(6) Use [ ] or [ ] to select and then press [OK].2 Specify the Read/write attribute.(1) Use [ ] or [ ] to specify .(2) Press [OK].Important When under is set to mode> using the Operation Panel of the machine, card direct printing cannot bedone. After using the Card Slot as the memory card drive of the computer,remove the memory card, then be sure to set to only mode>.Read-only mode: The Card Slot is used only for reading. Be sure to select thismode when printing photos from a memory card.Read/write mode: The Card Slot is used as the memory card drive of thecomputer. Photo data can be written into the memory card.Note When using the Card Slot as the memory card drive of the computer, theremoval operation from the computer is needed before removing thememory card from the machine.Right-click the removable disk icon and click [Eject]. If [Eject] is notdisplayed on the screen, ensure that the Access Lamp is not flashing andremove the memory card.Be sure to drag the icon into the Trash.
