Chapter 12 137Troubleshooting Scanned image not displayed properly Trouble scanning with MP Navigator Image position and size incorrect when scanning from the machine’soperation panelCause ActionScanned image prints out enlarged(reduced).Set the printing size in the application software.Example: ArcSoft PhotoStudio1. With the image in the selected state, click the [File] menu and select[Print].2. Move the print size slider left or right in the Print dialog to adjust theprinting size. The preview image to the left will change size accordingly.Scanned image enlarged (reduced)on the computer monitor. z Change the display setting in the application software.z Images opened in [Paint] or [Imaging] may be displayed in full size andyou may not be able to reduce its display size. Open the image in anapplication software supplied with the scanner instead. Refer to the on-screen manual for each application software for the detailedprocedures.z Change the resolution setting in the scanner driver and rescan. Thehigher the resolution, the larger the resulting image will be.z Some application software do not display clear images at small imagedisplay settings. Set the scale to 100%.Scanned image won’t open. The file name extension is not supported by the application software.Rescan the image using an application software, such as ArcSoftPhotoStudio, and change the file name extension when saving the image.Refer to the on-screen manual for each application software for thedetailed procedures.Cause ActionThe original may not be scannedcorrectly when [Document Size] isset to [Auto Detect].Set the [Document Size] to the actual size of the original, and scan itagain. If the size you need cannot be set, scan to a larger size and trim it.For more information, refer to the Scan Guide.Cause ActionMP Navigator settings do not matchthe originals.Set the MP Navigator [Document Type] and [Document Size] to matchthose of the originals being scanned. For more information, refer to theScan Guide.
