Advanced Guide > Troubleshooting > FINE Cartridge Holder Does Not Move to the Position for ReplacingU325FINE Cartridge Holder Does Not Move to the Position forReplacingCheck 1: Is the POWER lamp off?Check if the POWER lamp is lit green.The FINE Cartridge Holder will not move unless the power is on. If the POWER lamp is off, close theScanning Unit (Cover) and turn the machine on.While the POWER lamp is flashing green, the machine is initializing. Wait until the POWER lampstops flashing and remains lit green, and then open the Scanning Unit (Cover) again.Check 2: Is an error code displayed on the LED?Close the Scanning Unit (Cover), confirm the error code is displayed, take the appropriate action toresolve the error, and then reopen it. For details on how to resolve the error, see An Error Code IsDisplayed on the LED.Check 3: Has the Scanning Unit (Cover) been left open for 10 minutes orlonger?If the Scanning Unit (Cover) is left open for more than 10 minutes, the FINE Cartridge Holder movesto the right to prevent the Print Head from drying out. Close and reopen the Scanning Unit (Cover) toreturn the FINE Cartridge Holder to the position for replacing.Check 4: Has the machine been printing continuously for a longperiod?Close the Scanning Unit (Cover), wait a while, then reopen it.If the machine has been printing continuously for a long time, the FINE Cartridge Holder may notmove to the position for replacing since the Print Head may overheat.NoteOpening the Scanning Unit (Cover) while printing moves the FINE Cartridge Holder to the right.Close the Scanning Unit (Cover), and reopen it after printing is complete.Page topPage 635 of 707 pagesFINE Cartridge Holder Does Not Move to the Position for Replacing
