Remove the covers as necessary to clean,inspect, or repair the inside of the machine.Those covers that may be removed by mereremoval of mounting screws are left out of discus-sions.1. Removing the Process Cover1) Open the front door.2) Slide out the duplexing unit assembly q, andshift the jam removal lever w in the direction ofthe arrow.Figure 4-1043) Remove the three mounting screws, andremove the process cover e.If the back of the process cover is soiled,wipe it with a moist cloth (especially thearea around the magnet plate).At this time, check to make sure that nodroplet of water remains.2. Removing the Pick-Up Assembly Cover1) Open the front door.2) Remove the mounting screw q, and removethe jam removal grip w; then, remove thescrew, and remove the jam removal handle e.3) Remove the three mounting screws r, and liftthe pick-up assembly cover t slightly toremove.Figure 4-1053. Removing the Duplexing Unit Front Cover1) Open the front door, and slide out the duplex-ing unit.2) Remove the mounting screw q, and removethe duplexing unit releasing lever w.Figure 4-1064. MECHANICAL SYSTEMCOPYRIGHT © 1996 CANON INC. CANON NP6085 REV.0 JULY 1996 PRINTED IN JAPAN (IMPRIME AU JAPON) 4-3123145322 1Caution:
