Error Message Appears on a PictBridge (Wireless LAN) CompliantDeviceThe following are the possible errors that may occur when printing directly from a PictBridge (Wireless LAN)compliant device and the countermeasures to clear them.Note• This section describes errors that are indicated on Canon-brand PictBridge (Wireless LAN) compliantdevices. The error messages and operations may vary depending on the device you are using. Forerrors on non-Canon PictBridge (Wireless LAN) compliant devices, check the status of the Alarm lampand take the appropriate action to clear the error. For details, see If an Error Occurs.Support Code List• For the errors indicated on the PictBridge (Wireless LAN) compliant device and their solution, also referto the instruction manual of the device. For other troubles on the device, contact the manufacturer.Error Message on thePictBridge (WirelessLAN) CompliantDeviceAction"Printer in use" If the machine is printing from the computer or warming up, wait until the job ends.When it is ready, the machine starts printing automatically."No paper" Load paper, and select Continue* in the display on your PictBridge (Wireless LAN) compliantdevice.* To resume printing, you can also press the Color button or the Black button on themachine instead of selecting Continue on the device."Paper jam" Select Stop in the display on your PictBridge (Wireless LAN) compliant device to stopprinting.Remove the jammed paper, load new paper, press the Color button or the Black button onthe machine, then try printing again."Printer cover open" Close the cover on the machine."No print head" Check the number of how many the Alarm lamp flashes and take the appropriate action toresolve the error.If an Error Occurs"Waste tank full"/"Inkabsorber full"The ink absorber is nearly full.Check the number of how many the Alarm lamp flashes and take the appropriate action toresolve the error.If an Error Occurs"No ink"/"Ink cassetteerror"Check the number of how many the Alarm lamp flashes and take the appropriate action toresolve the error.If an Error Occurs"Hardware Error" Check the number of how many the Alarm lamp flashes and take the appropriate action toresolve the error.If an Error Occurs671
