COPYRIGHT © 1999 CANON INC. CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A. 11-37CHAPTER 11 INSTALLATIONFigure 11-A602bit Position Description RemarksSW1SW5*1: Set SW5-4 (DIP switch) to OFF if the Control Card-V is used or remote control only by the CopyData Controller-A1 is used (i.e., not using ID input, paper size control, toner color control, copy modecontrol, paper type control).1~345612345,6OFFOFFONONOFFONOFFONOFFONOFFONOFFONOFFFor normal operation.For serial communication.For IPC communication.For use of a central control device.For normal operation or for remotecontrol using a commerciallyavailable modem.For RAM clear.For normal operation.For factory adjustment.For normal operation.For control of Inch papers (11×17,LTR, LGL, STMT).For control of AB papers (A3, A4,B4, B5).For service mode.For normal operation.For group control.For no group control.NP6030, NP6060, NP8530, NP9800Other than above.Requires the Interface Board-B1.For remote control using acommercially available modem,requires a modem and the InterfaceBoard-B1.For controlling paper other thanthose on the left, make settings inservice mode. See C.10. "Checkingthe Operation."*1OFF Not used.Table 11-A6012.3)If group control is not used, shift SW5-4(DIP switch) to OFF.To install the Interface Board-B1, Com-munication Control Board-A1, or Inter-face Board-A1, see the descriptions under"Setting the Board" in their respective In-stallation Procedures.16 SW4SW1 ON SW5 ONLED6LED5LED4LED3LED2LED1SW2SW3JB2JB1JA1JA2EPROMSRAMCPU IPCJC9JC6JC5JC8J516SW116 16SW5Photocoupler
