COPYRIGHT © 1999 CANON INC. CANON imageRUNNER 600 REV.1 JAN. 2000 PRINTED IN U.S.A. 11-21CHAPTER 11 INSTALLATIONIII . RELOCATING THE COPIERIf the copier must be relocated by truck or other means of transportation, perform the follow-ing:Caution:A. Keep the following in mind when using stairs to deliver the copier in or out of the user's:1. Remove the fixing/feeding unit, holding tray, and copy paper from the copier, andtransport them separately from the copier.(If the ADF is installed, be sure to remove it also.)2. When holding the copier, do not use the hand grips of the pickup assembly/deliveryassembly; instead, support it by grasping the four corners of its bottom.B. Shift up the two adjusters (front) on the copier's bottom to make sure that they are un-locked. Further, take care so that the adjusters will not slip off the copier during transpor-tation.C. When delivering the copier into/out of the user's, be sure to remove the accessories (sidepaper deck, finisher).WorkMake a copy in Direct.Remove all paper from allcassettes.Turn off the power switch, anddisconnect the power plug from theoutlet.Fix the No. 2 mirror mount in placewith the locking plate workingthrough the left cover side.Remove the developing assembly.Tape the transfer chargingassembly, fixing/feeding unitreleasing lever, and lower feedingassembly in place.Tape the front door, hopper cover,each cassette, and main right door(upper/lower) in place.Place A3 copy paper on thecopyboard glass, and tape the ADFin place.ChecksCheck to make sure that theNo. 2 mirror mount will notmove.Transport the developingassembly separately.RemarksNo.12345678
