5. Replace the lower outboard plastic snap-in retainerin the fender bracket, if needed.6. Reconnect the electrical harness at the back side ofthe headlamp assembly.7. Push the headlamp assembly straight into thevehicle engaging the headlamp pin into thesnap-in retainer and adjusting the lamp inboard sideto clear past the front fascia.8. Reinstall the two fasteners on top of the headlampassembly.9. Reinstall the screw at the lower inboard side of theheadlamp assembly through the hole in the bracketinto the headlamp.10. Reinstall the fasteners along the top surface of thefront fascia.To replace the sidemarker and/or parking lamp bulb(s),do the following:1. Turn the bulb socket counterclockwise to remove itfrom the assembly.2. Replace the bulb. See Replacement Bulbs onpage 5-58 for the proper bulb number.3. To reinstall the headlamp assembly, reverseSteps 5 through 10 of the procedure listedpreviously.Front Turn Signal and Fog LampsTo replace the front turn signal and/or fog lamp bulb(s),do the following:1. Remove the protection shield located on theunderside of the front of the vehicle by pullingout the push-pins located on the underside of theshield. If you are replacing a bulb on thepassenger’s side, also use a tool to remove thefasteners that attach the front fascia extension panelin the wheelhouse.2. Remove the two screws located on the inboard sideand bottom of the lamp assembly that attach thelamp assembly to the front fascia.3. Remove the lamp assembly from the front fascia byrotating the lamp assembly rearward to disengagethe outboard hooks of the lamp from the slotsin the front fascia.4. Disconnect the electrical harness connector fromthe back side of the lamp assembly.5. Remove the six Torx® screws located on theaccess cap.6. If you are replacing the fog lamp bulb, disconnectthe electrical connector from the back of the bulbsocket.5-56
