Black plate (69,1)Cadillac CTS/CTS-V (Europe LHD) Owner Manual - 2013 - CRC - 6/26/12Vehicle Care 10-69Adjust the front and rear tyres tothe recommended inflationpressure on the Tyre andLoading Information label afterthe tyres have been rotated. SeeTyre Pressure on page 10‑61and Vehicle Load Limits onpage 9‑9.Reset the Tyre Pressure MonitorSystem. See Tyre PressureMonitor Operation onpage 10‑64.Check that all wheel nuts areproperly tightened. See “WheelNut Torque” under Capacitiesand Specifications onpage 12‑2.{ WARNINGRust or dirt on a wheel, or on theparts to which it is fastened, canmake wheel nuts become looseafter time. The wheel could come(Continued)WARNING (Continued)off and cause an accident. Whenchanging a wheel, remove anyrust or dirt from places where thewheel attaches to the vehicle. Inan emergency, a cloth or a papertowel can be used; however, usea scraper or wire brush later toremove all rust or dirt.Lightly coat the centre of thewheel hub with wheel bearinggrease after a wheel change ortyre rotation to prevent corrosionor rust build-up. Do not getgrease on the flat wheelmounting surface or on thewheel nuts or bolts.When It Is Time for NewTyresFactors such as maintenance,temperatures, driving speeds,vehicle loading, and road conditionsaffect the wear rate of the tyres.Tread wear indicators are one wayto tell when it is time for new tyres.Tread wear indicators appear whenthe tyres have only 1.6 mm (1/16 in)or less of tread remaining. See TyreInspection on page 10‑67 and TyreRotation on page 10‑67.
