Driving and Operating 203the vehicle in Service Only Mode.The instruments and audio systemswill operate as they do in ON/RUN,but the vehicle will not be able to bedriven. The engine will not start inService Only Mode. Press thebutton again to turn the vehicle off.Starting the EngineMove the shift lever to P (Park) orN (Neutral). The engine will not startin any other position. To restart theengine when the vehicle is alreadymoving, use N (Neutral) only.CautionDo not try to shift to P (Park) if thevehicle is moving. If you do, youcould damage the transmission.Shift to P (Park) only when thevehicle is stopped.CautionIf you add electrical parts oraccessories, you could changethe way the engine operates. Anyresulting damage would not becovered by the vehicle warranty.See Add-On Electrical Equipment0 257.Starting Procedure (KeylessAccess)1. With the Keyless Accesssystem, the RKE transmittermust be in the vehicle. Pressthe ENGINE START/STOPbutton with the brake pedalapplied. When the enginebegins cranking, let go of thebutton.The idle speed will go down asthe engine gets warm. Do notrace the engine immediatelyafter starting it.If the RKE transmitter is not inthe vehicle, if there isinterference, or the RKEbattery is low, the DriverInformation Center (DIC) willdisplay a message. See Keyand Lock Messages 0 148.CautionCranking the engine for longperiods of time, by returning theignition to the START positionimmediately after cranking hasended, can overheat and damagethe cranking motor, and drain thebattery. Wait at least 15 secondsbetween each try, to let thecranking motor cool down.2. If the engine does not startafter five to 10 seconds,especially in very cold weather(below −18 °C or 0 °F), it couldbe flooded with too muchgasoline. Try pushing theaccelerator pedal all the way tothe floor and holding it there asyou press the ENGINE START/STOP button, for up to amaximum of 15 seconds. Waitat least 15 seconds betweeneach try, to allow the crankingmotor to cool down. When the
