Driving and Operating 201The switch used to adjust thepedals is on the center stack, to theleft of the touch screen.Press the top of the switch to movethe pedals closer to your body.Press the bottom of the switch tomove the pedals away.Before you start driving, fully pressthe brake pedal to confirm theadjustment is right for you.The vehicle may have a memoryfunction, which lets pedal settingsbe saved and recalled. See MemorySeats 0 58.Ignition PositionsVehicles with Keyless Access havepushbutton starting.Pressing the button cycles it throughthree modes: ACC/ACCESSORY,ON/RUN/START, and Stopping theEngine/OFF.The transmitter must be in thevehicle for the system to operate.If the pushbutton start is notworking, the vehicle may be near astrong radio antenna signal causinginterference to the Keyless Accesssystem. See Remote Keyless Entry(RKE) System Operation 0 29.To shift out of P (Park), the vehiclemust be in ACC/ACCESSORY orON/RUN and the brake pedal mustbe applied.Stopping the Engine/LOCK/OFF (No Indicator Lights) : Whenthe vehicle is stopped, press theENGINE START/STOP button onceto turn the engine off.If the vehicle is in P (Park), theignition will turn off, and RetainedAccessory Power (RAP) will remainactive. See Retained AccessoryPower (RAP) 0 204.If the vehicle is not in P (Park), theignition will return to ACC/ACCESSORY and display themessage SHIFT TO PARK in theDriver Information Center (DIC).See Transmission Messages 0 154.When the vehicle is shifted intoP (Park), the ignition system willswitch to OFF.Do not turn the engine off when thevehicle is moving. This will cause aloss of power assist in the brakeand steering systems and disablethe airbags.
