Bosch AMAX panel 2000 Installation Manual

Also see for AMAX panel 2000 EN ICP-AMAX-P-EN: User guide User guide

Contents

AMAX panel 2000 / AMAX panel 2000 EN System Informations 2 | en 69Bosch Sicherheitssysteme GmbH Installation Manual F.01U.241.127 | V4 | 2011.128.3 System Event Memory RecallThere are two Event Memorys, one for ALL EVENTS and one for EN EVENTS. Up to 254 systemevents can be recorded in event memory in chronological order. These events are with dateand time information and stored in non-volatile memory.For Event records refer toTable 8.1, Page 66.8.3.1 Keypad Play Back System EventsWhen Installer Code/Master Code function is used to play back the events, only five systemevents in below table can be shown using the keypad indicators.Detailed process is as below:1. When the Code holder operates the below command:CODE + [5] + [#]The system display the above five types of system events.2. Other events are not displayed on the keypad.3. Each event displays one second and activate the short beep sound on the keypad. Theevents are played bace in reverse chronological order.Press [#] to exit from the Event Play Back Mode at anytime.8.4 Output ProcessThe AMAX panel 2000 / AMAX panel 2000 EN Control Panel has three outputs on the mainboard and 8 outputs on the DX3010 relay module. The Output 1 is used as Siren alarm. Duringthe alarm duration, the system can reset the alarm by command “reset” . The other outputscan be programmed to follow up different events.8.4.1 Output Events Option0 – No output activate for the eventsThis output doesn’t operate for any events codes. OC outputs are open status. Relay is normalopen status.1 – System DisarmedThe output operates on below conditions:1. System disarmed after system reset2. System operated the disarm commandThe output is reset:1. When the system is armed2. When the output programmed duration is up2 – System ArmedThe output operates on below conditions:1. System armed after system resetSystem operated the arm command and until system is armed. (When system is operating thearm command, the system will arm after the exit delay time is up.)Event Keypad IndicationZone Alarm or Tamper (Zone1-8) LED 1-8 lightTamper Alarm FAULT Indicator lightsSTAY Arming STAY Indicator lightsAWAY Arming AWAY Indicator lightsSystem Disarming All indicators are extinguished