Bosch AMAX panel 2000 Installation Manual

Also see for AMAX panel 2000 EN ICP-AMAX-P-EN: User guide User guide

Contents

34 en | Fault and Tamper Description AMAX panel 2000 / AMAX panel 2000 ENF.01U.241.127 | V4 | 2011.12 Installation Manual Bosch Sicherheitssysteme GmbH4. When the fault is reset, send the restored report to the configured destinations. TheFAULT indicator is turned off when there is no other system fault.5.3.2 Warning Device 1 ShortCondition:Warning Device output is shorted.Restore:Warning Device output short is removed and fault is reset.Supervise:1. Monitor the voltage by MPU.2. Report the siren fault to the configured destination programmed on location 140.3. Slow flash FAULT indicator (refer to the detailed description in chapter keypadindicators)4. When the fault is reset, send the restored report to the configured destinations. TheFAULT indicator is turned off when there is no other system fault.5.3.3 Warning Device 2 DisconnectedCondition:Warning Device is disconnected.Restore:Supervise:1. Monitor the voltage by MPU.2. Report the siren fault to the configured destination programmed on location 140.3. Slow flash FAULT indicator (refer to the detailed description in chapter keypadindicators)4. When the fault is reset, send the restored report to the configured destinations. TheFAULT indicator is turned off when there is no other system fault5.3.4 Warning Device 2 ShortCondition:Warning Device output is shorted.Restore:Warning Device output short is removed and fault is reset.Supervise:1. Monitor the voltage by MPU.2. Report the siren fault to the configured destination programmed on location 140.3. Slow flash FAULT indicator (refer to the detailed description in chapter keypadindicators)4. When the fault is reset, send the restored report to the configured destinations. TheFAULT indicator is turned off when there is no other system fault5.4 Telephone Line FaultCondition:Telephone line is broken or disconnected.Restore:Telephone line is restored or connected and fault is reset.Supervise:1. Monitor the telephone line by MPU all the time when the telephone is idle.2. Report the telephone line fault to the configured destination programmed on location140.