AMAX panel 2000 / AMAX panel 2000 ENF.01U.249.500en User Guide

Introduction

Arming and Disarming the System

Arming in STAY mode

Faults or Tamper conditions

Walk test mode

Event Memory Recall mode

Reset the Control Panel

Bypassing

Enable / Disable the installers code

Change individual code

Keypad alarm operation commands

Domestic Dialing

Glossary

Bosch AMAX panel 2000 User Manual

Enable / Disable the installer codes

AMAX panel 2000 EN ICP-AMAX-P-EN

Short Information

System Overview

Installation

Setting date and time

AMAX panel 2000 / AMAX panel 2000 EN Zone Defaults

Programming with the ICP-EZPK Programming key

Prerequisites for an EN-conform Setup of the System

User Guide

Arming the System

Forced arming

Bypassing Faults and Tamper conditions (Except Zone Tampers)

Keypad medical alarm

Fault and Tamper Description

Accessory Modules Fail

Keypad 2 fail

Power Faults

Bosch Option Bus Power Supply Fail

Warning Device 1 Short

Date and Time Fail

Communication Failure 4

Keypad lock out

External Fault

System Functions

Siren Test

Event Memory Recall Mode

Initiate a Modem Call

Bypass all Faults and Tamper conditions (Except zone Tamper)

Add/delete User Codes

Change Domestic Phone Number

Command 960 – Exit from installer's programming mode with saving the programming data

Command 963 – Copy the programming key to the control panel

System Informations 1

Software

Remotely Arm/Disarm System by Programming Softwares

CFSK Format

Telephone number for Receiver 1 - 4/IP Address and Port

Report Transmission Sequence

Receiver 1 - 4 Subscriber ID Number

User Codes

System Informations 2

Zone programming

Zone Bypass

Zone Tamper

System Option Programming Definition

System Report and Memory Definition

Auto Test Report

System Event Memory Recall

Output Type

Exit Time

B420/DX4020/ITS-DX4020G GSM GPRS Communication Module

Technical Data

Interface Description

Programming sheets

Domestic Programming

Test Report Time Interval Setting

Keypad Lockout

AC Fault Detect time

Output Programming

Installer/User Code Programming

Troubleshooting

AMAX panel 2000 ICP-AMAX-P

Bosch AMAX panel 2000 User Manual

Product

Learn More

Legal


Contents Table Of Contents Introduction Arming and Disarming the System Arming in STAY mode Faults or Tamper conditions Walk test mode Event Memory Recall mode Reset the Control Panel Bypassing Enable / Disable the installers code Change individual code Keypad alarm operation commands Domestic Dialing Glossary	AMAX panel 2000 / AMAX panel 2000 ENF.01U.249.500en User Guide Next / 24