AGA APRO30DFSS User Manual

AGA APRO30DFSS User Manual Manual pdf 23 page image

19INSTALLATIONCheck the appliance is electrically safe when you have flnished.Electrical ConnectionWhen installed the range must be electrically grounded inaccordance with local codes or; in the absence of local codeswith the National Electrical Code ANSI/NFPA 70, latest edition.In Canada the range must be installed in accordance with thecurrent CSA Standard C22.1 – Canadian Electrical Code Part 1.A copy of this standard may be obtained from: NationalFire Protection Association, 1 Battery March Park, Quincy,Massachusetts 02269-9101.The power supply must be the correct polarity. Reversepolarity will result in continuous sparking of the electrodes,even after flame ignition. If there is any doubt as to whetherthe power supply has the correct polarity or grounded, haveit checked by a qualified electrician.Electrical Requirementsn For personal safety, do not use an extension cordwith this appliance. Remove the house fuse or openthe circuit breaker before beginning installation.This appliance must be supplied with the proper voltageand frequency, and connected to an individual, properlygrounded branch circuit, protected by a circuit breaker ortime-delay fuse, as noted on the rating plate.Wiring must conform to National Electric Codes. If the electricservice provided does not meet the above specifications,have a licensed electrician install an approved outlet.Power Supply Cord Kit (not included)The user is responsible for connecting the power supply cordto the connection block located behind the back panel accesscover (Fig. 7-1).The appliance may be connected by means of permanent“hard wiring”; flexible armored or non-metallic shieldedcopper cable (please check local National Electrical Codes).Risk of fire or electrical shock exists if an incorrect size rangecord kit is used, the Installation Instructions are not followed,or the strain relief bracket is discarded.The connection cord MUST HAVE 4 conductors – (cords with3 conductors are NOT ALLOWED – connection of an EarthStrap between Neutral and the Chassis Ground on Dual FuelCookers is not allowed). The Terminal on the end of eachconductor must be either a closed loop or open spade lugwith upturned ends. The cord must have a strain-relief clamp.n CAUTION: Whilst connecting the range do not loosenthe fixings which secure the factory-installed wiringto the terminal block. Electrical failure or loss ofelectrical connection may occur.n Only a 4 conductor power supply cord kit rated120/240 volts, 30A amperes and marked for use withranges shall be usedFig. 7-1