AGA APRO30DFSS User Manual

AGA APRO30DFSS User Manual Manual pdf 17 page image

1312notchStainless Steel Main TopLift away pots or pans from main top. Remove grates fromspillage area and carefully place in a sink of warm soapywater. Wipe loose debris from main top. Avoid using anyabrasive cleaners including cream cleaners on brushedstainless steel surfaces. For best results use a liquid detergentcleaner. Rinse with cold water and thoroughly dry with aclean, soft cloth. Ensure all parts are dry before repositioning.n Avoid using any abrasive cleaners including creamcleaners on brushed stainless steel surfaces.n Never use caustic or abrasive cleaners as these willdamage the surface.Control Panel and Oven DoorThe control panel and control knobs should only be cleanedwith a soft cloth wrung out in clean hot soapy water – buttake care that no surplus water seeps into the appliance. Wipewith a clean dampened cloth then polish with a dry cloth.The oven door should only be cleaned with a soft clothwrung out in clean, hot soapy water.Removing the Oven DoorThe oven door can be removed for ease of cleaning.Open the oven door fully and release the saddle bracketssituated either side (Fig. 5.3). Ensure that the saddle bracketsare opened to their end positions, to prevent the hinges fromretracting into the oven door.Close the oven door until it is half closed then carefully liftand un-hook the door panel from the range (Fig. 5.4).To re-assemble, ensure that the saddle bracket and hingemechanisms are correctly positioned (Fig. 5.5).Carefully replace the door panel using the hinge locatingnotches, open it fully then close the saddle bracket (Fig. 5.6).n DO NOT use harsh abrasive cleaners or sharp metalscrapers to clean the oven door glass since they canscratch the surface, which may result in shattering ofthe glass.Oven Door GasketAvoid cleaning the oven door gaskets. If you need to removea build-up of food or grease follow these procedures:Dampen a sponge with clean hot water and gently wipe thedebris from the affected area. DO NOT rub.Press a dry towel gently on the gasket to dry.n DO NOT use any abrasives or cleaners on the gasket.Fig. 5.4Fig. 5.5Fig. 5.6Fig. 5.3