6 Reference information6.7. Special tools1913HAC 026048-001 Revision: -© Copyright 2006 ABB. All rights reserved.6.7. Special toolsGeneralAll service instructions contain lists of tools required to perform the specified activity. Therequired tools are a sum of standard tools, defined in section Standard toolkit on page 190,and of special tools, listed directly in the instructions and also gathered in this section.Special toolsThe table below specifies the special tools required during service procedures. The tools arealso specified directly in concerned procedures for repair.Content, toolkit for service, 3HAC023963-026The table below specifies the loose parts in the toolkit for service. The item numbers refer tothe items shown in the figures for each assembly of the complete tools, on following pages.Item Description Art. no. Note- Guide pins 3HAC024097-006 3 pcs required. Length: 62 mm.Diameter: 6 mm. Thread: M6x12.Used for guiding the shaft end of theupper arm into place.- Hydraulic pump, 80 Mpa 3HAC13086-1- Press tool, parallel barbearing3HAB6324-1- Mounting tool, parallel bar 3HAB6331-1- Measuring tool, motor 3HAB7887-1 Used when refitting motor axes 1, 2and 3.- Extended KM nut (KM7) 3HAC023963-040 Length: 135 mm.- Toolkit for service 3HAC023963-026 The kit contains loose parts that areassembled into different tools fordifferent service occasions.The content is specified in thefollowing table (Content, toolkit forservice, 3HAC023963-026 on page191).The different assemblies are shownin the figures on the followingpages, as in the service proceduresthat require the tool assembly.H Press sleeve 3HAC023963-013Item Description Art. no. NoteA Hydraulic cylinder 3HAC11731-1B Press washer 3HAC023963-007C Hex socket head cap screw 9ADA183-25 2 pcs, M6 x 25D Connection rod - M16, length= 400 mmE Nut 3HAC5507-1F Sleeve 3HAC023963-027 D= 70 mmG Nut 3HAC023963-028 D= 28 mmContinues on next page
