Remote-ping Configuration Example 889Displaying Remote-ping ConfigurationAfter the above-mentioned configuration, you can use the display commands toview the results of the latest test and history information.Remote-pingConfigurationExampleICMP Test Network requirementsThe Switch 7750 serves as the remote-ping client. A remote-ping ICMP testbetween the switch and another switch uses ICMP to test the round trip time (RTT)for packets generated by the remote-ping client to travel to and back from thedestination switch.Network diagramFigure 241 Network diagram for the ICMP testConfiguration procedure■ Configure remote-ping Client (Switch A):# Enable remote-ping client.<7750> system-view[7750] remote-ping-agent enable# Create a remote-ping test group, setting the administrator name toadministrator and test tag to ICMP.[7750] remote-ping administrator icmp# Configure the test type as icmp.Configure the number ofconsecutive unsuccessfulremote-ping probes beforeTrap outputprobe-failtimes times OptionalBy default, Trap messages aresent each time a probe fails.Table 704 Display remote-ping test resultsOperation Command DescriptionDisplay test history display remote-ping history [administrator-nameoperation-tag ]Available in any view.Display the results of thelatest testdisplay remote-ping results [administrator-nameoperation-tag ]Table 703 Configure the remote-ping client to send Trap messagesOperation Command DescriptionSwitch A Switch Bremote- ping ClientIP network10.1.1.1/8 10.2.2.2/8
