Static Route Configuration Example 287Static RouteConfigurationExampleNetwork requirementsAs shown in Figure 69, it is required that all the hosts/Layer 3 switches in thefigure can communicate with each other by configuring static routes.Network diagramFigure 69 Static route configurationTable 212 Display the routing tableOperation Command DescriptionDisplay routing table summary display ip routing-table You can execute thedisplay command in anyview.Display routing table details display ip routing-tableverboseDisplay the detailed information of aspecific routedisplay ip routing-tableip-address [ mask ][ longer-match ][ verbose ]Display the routes in a specifiedaddress rangedisplay ip routing-tableip-address1 mask1ip-address2 mask2[ verbose ]Display the routes discovered by aspecified protocoldisplay ip routing-tableprotocol protocol[ inactive | verbose ]Display the tree-structured routingtable informationdisplay ip routing-tableradixDisplay the statistics of the routingtabledisplay ip routing-tablestatisticsClear the statistics about a protocol inthe routing tablereset ip routing-tablestatistics protocol { all |protocol }Use the reset commandin user view.1.1.5 .2/24Switch BSwitch ASwitch CHost CHost AHost B1.1.5.1 /241.1.1.1/241.1.1 .2/241 .1.2.2/241 .1.2.1/24 1 .1.3.2/241.1 .3.1/241.1.4.1/241.1.4.2 /24
