3Com 7757 Configuration Manual

Also see for Switch 7754: Product guide Datasheet Datasheet Installation guide Product guide

Contents

3Com 7757 Configuration Manual Manual pdf 300 page image

300 CHAPTER 33: RIP C ONFIGURATION# Configure RIP.system-view[SwitchC] rip[SwitchC-rip] network 117.102.0.0[SwitchC-rip] network 110.11.2.0Troubleshooting RIPConfigurationSymptom: The layer 3 switch cannot receive any RIP update packet when thephysical connection between the switch and the peer routing device is normal.Solution:■ Use the display current-configuration configuration rip command to verifyRIP is enabled on the interface with the network command.■ Use the display this command in VLAN interface view to verify the undo ripwork command was not executed on the interface connected to the peer.■ Use the display this command in VLAN interface view to verify the RIP packetssent by the two ends have the same format.The peer routing device is configured to work in the multicast mode (for example,the rip version 2 multicast command is executed) but the multicast mode is notconfigured on the corresponding interface of this switch.